How to clear clogged nozzles on my MIMAKI Printer?
To clear clogged nozzles, you can try the following: * Perform head cleaning. * Perform print head nozzle washing. * Perform [MENU] > [Maintenance] > [INK FILL].
What to do if the ink has leaked from my MIMAKI UCJV300?
If an ink leak occurs, immediately turn off the main power and unplug the power cable. Then, contact your local dealer or our service office.
What to do if the light-blocking cover comes off my MIMAKI Printer?
If the light-blocking cover comes loose, reattach it by following these steps: 1. Insert the lug on one side of the light-blocking cover into the corresponding hole in the tank. 2. Insert the lug on the other side while pushing in toward the first hole.
Why does the media jam or get dirty in my MIMAKI Printer?
To address media jams or dirty media, consider the following: * Ensure you are using the recommended media. * Avoid using curled media or media with folded ends. * Use the take-up unit to adjust or reload the media.
How to fix image defects occurring on my MIMAKI UCJV300?
To address image defects, try the following: * Remove any paper scraps or debris from areas the head passes over, such as media holders. * Perform head cleaning. * Perform feed correction. * Clean the wiper. * Clean the cap rubber. * Clean the carriage underside.
How to correct misaligned print and cut positions on my MIMAKI UCJV300 Printer?
If the print and cut positions are misaligned, use the MIMAKI RIP software (RasterLink) to print a correction pattern. Then, check the pattern and manually input correction values.
Why does the cut position shift on my MIMAKI UCJV300?
If the cut position shifts, it may indicate a problem with the register mark sensor. Perform the operation used to check the responsiveness of the register mark sensor. Note that you cannot check the responsiveness manually.
How to troubleshoot a MIMAKI Printer when the power does not turn on?
To resolve the issue of the power not turning on, ensure the power plug is securely inserted into the power outlet, use the power cable provided, and turn on the main power.
Why is ID cut not performed on my MIMAKI Printer UCJV300/150, CJV300 Plus series?
If the UCJV300/150, CJV300 Plus series printer isn't performing ID cuts even after detecting register marks, ensure the following: * Establish a connection via USB or Ethernet. * Register the UCJV300/150, CJV300 Plus series with Cutting-Link. * Ensure that the register mark shape and size match the print register mark data on the UCJV300/150, CJV300 Plus series.
What to do if MIMAKI UCJV300 Printer doesn't cut continuously with multiple register marks?
If your MIMAKI UCJV 300/150 Printer doesn't cut continuously when multiple register marks with different IDs are attached, take these steps: * Ensure all register marks have the same shape and size. * Enter the correct settings under [cutting] - [register mark detection] - [detection area] on your UCJV 300/150.
General| Print Technology | UV-LED inkjet |
|---|---|
| Max Print Resolution | 1200 x 1200 dpi |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Ink Type | UV-curable ink |
| Media Thickness | 1 mm or less |
| Interface | USB, Ethernet |
| Operating System Compatibility | Windows 10, Windows 8.1, Windows 7 |
| Ink Colors | CMYK, White, Clear |
To Next Page
