MIMAKI UCJV300 Series - Warning Label Identification and Details

4. Consumable Item Replacement
20
7
Mount a new wiper.
Lug
8
Once replacement is complete, close the cover, then press the [ENTER] key.
• The wiper usage count is reset.
Cap Absorber Replacement
This product maintains a usage count. The “Replace Cap Absorber” message appears on the display when a
preset count is reached.
(This is supported in firmware version 2.5 and later.)
If the cap absorber is very dirty or if ink drips on to the media, replace with a new cap absorber.
1
The “Replace Cap Absorber” message appears on the display.
2
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Station] > [Carriage Out] > [Station Maint.], then press the [ENTER] key.
• The carriage moves over the platen.
• The cap absorber usage count is reset.
4
Turn off the power.
5
Open the front cover.
6
Remove the cap absorber.
• Push up the two tabs at the front to remove the cap absorber.
Cap absorber
• Avoid ink dripping when removing the cap absorber.