MIMAKI UJF-6042 MkII - Setting the X Offset (LOC); Setting the X Offset (REM); Setting the y Offset (LOC); Setting the y Offset (REM)

3-6
Chapter 3 Setup
Setting the X offset (REM)
Use the following steps to accurately set the X origin of
the online print.
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “SET ORIGIN” ,
and press the key.
3
Press to select “X offset (REM)” ,
and press the key.
4
Press to set the X-axis origin
position, and press the key.
• The value in the parentheses indicates the distance
from the origin to the maximum effective area.
5
Press the key several times to
end the setting.
Setting the Y offset (REM)
Use the following steps to accurately set the Y origin of
the online print.
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “SET ORIGIN” ,
and press the key.
3
Press to select “Y offset (REM)” ,
and press the key.
4
Press to set the Y-axis origin
position, and press the key.
• The value in the parentheses indicates the distance
from the origin to the maximum effective area.
5
Press the key several times to
end the setting.
Setting the X offset (LOC)
Use the following steps to accurately set the X origin of
the built-in pattern such as test print.
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “SET ORIGIN” ,
and press the key.
3
Press to select “X offset (LOC)” ,
and press the key.
4
Press to set the X-axis origin
position, and press the key.
• The value in the parentheses indicates the distance
from the origin to the maximum effective area.
5
Press the key several times to
end the setting.
Setting the Y offset (LOC)
Use the following steps to accurately set the Y origin of
the built-in pattern such as test print.
1
Press the
(MENU)
in LOCAL mode.
2
Press to select “SET ORIGIN” ,
and press the key.
3
Press to select “Y offset (LOC)” ,
and press the key.
4
Press to set the Y-axis origin
position, and press the key.
• The value in the parentheses indicates the distance
from the origin to the maximum effective area.
5
Press the key several times to
end the setting.