3-9
Chapter 3 Setup
3
2
2
2
SETUP MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : FEED COMP./INK LAYER/Logical Seek/REFRESH
• When you operate the machine according to the contents specified with the RIP software, set each item to “Host” when
registering this machine type. When you set it other than “Host”, the machine operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Initial value Outline
FEED COMP.( P.3-10) -9999 ~ 0 ~ 9999 0
Used to print a pattern for
correcting a media-feeding rate
and correct it.
LOGICAL SEEK( P.3-10) HOST / ON / OFF HOST
Sets the scan movable area
during printing.
INK LAYERS ( P.3-11) HOST / 1 ~ 9 HOST
Sets the number of layers in which
ink is to be applied.
REFRESH LEVEL ( P.3-11) HOST / 10 ~ 3 HOST
Sets the interval of refresh
performed during printing.
UV MODE ( P.3-11) ON / OFF / NO PRINT ON
Sets the UV irradiation during
printing.
UV AdjVal ( P.3-11)
-50% ～ 0 ～ 50%
0%
The pre-set UV lamp light intensity
can be changed.
(FW: supported from UJF-MkII
Ver5.2 or later, UJF-MkIIe Ver2.0
or later)
WORK CHANGE ( P.3-11) ON / OFF OFF
Set whether to return to the local
mode or keep the remote mode
after online drawing.
FAN MODE ( P.3-12) AUTOMATIC/MANUAL AUTO Sets the vacuum function.
AUTO CLEANING ( P.3-12) ON / OFF ON
Sets the automatic cleaning
operation for the head performed
before printing.
PRINT FLUSHING LEVEL ( P.3-13) 0 ~ 3 0
Sets the flushing amount before
printing.
MAPS4 ( P.3-13) MANUAL / AUTO AUTO
Perform setting to reduce stripes
between passes.
Misregistration
adjust
(P.3-14)
Feed Direction
-8 ~ 0 ~ 8 0
Correct the mis-registration occurs
at printing the color/spot color
version.
Feed Direction
Reverse Print -2.00 ~ 0.00 ~ 2.00mm 0.00
LT mode
(P.3-15)
ON / OFF OFF
Set LT mode when you need more
flexibility than the default UV
mode print.
SUCTION WIPER
(P.3-15)
WIPING AFTER
PRINT
SELECT HEAD
6042MkII/6042MkII e :
HEAD1 to 3
3042MkII/3042MkII e :
HEAD1 to 2
6042MkII/
6042MkII e:
HEAD4
3042MkII/
3042MkII e:
HEAD3
Displayed only when SUCTION
WIPER is in use.
Set the heads for executing
WIPING AFTER PRINT and
EXEC INTERVAL.
EXEC INTERVAL
FILE/WORK CHANGE
(FILE: 1 to 5)
FILE: 1
Scan Speed ( P.3-15) STANDARD / LOW STANDARD
Sets the scanning speed during
printing.
To Next Page
Loading...
