MIMAKI UJF-6042 MkII - Sub Tank Maintenance

Chapter 4 Maintenance
4-13
1
2
2
4
5
6
(3) Insert it in the original position by holding the
protrusions at both ends of the wiper.
6
(When using suction wiper) Clean the
suction wiper and around the wiper.
• Clean the wiper and the area around wiper with a
clean stick dipped in maintenance Maintenance
liquid for maintenance.
• Wipe off so that maintenance Maintenance liquid
for maintenance will not remain.
Clean the tube once a week to prevent wiper
tube clogging.
(1) Fill the dropper with 3 cc cleaning solution.
• Use the dropper scale for the liquid measure.
(2) Fill the suction wiper with the cleaning solution from
its mouth.
• Speed to fill with cleaning solution: 1 cc/second
7
Fill up the cap with cleaning solution for
maintenance．
• Suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
8
Press the key.
9
Close the maintenance cover and press
the key.
10
Press to set the time for the
cleaning solution to be left as it is.
• Set Value:1 to 10 min (by the unit of 1 min)
11
Press the key.
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves to the maintenance position.
12
Open the maintenance cover.
13
Fill up the cap with cleaning solution for
maintenance.
• Suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
14
Close the maintenance cover and press
the key.
• After its initial operation, the machine returns to
step2.
Sub tank maintenance
Protrusion
Suction wipe
Suction wipe
Area around wiper
Area around wiper
UJF-3042MkII/3042MkII EX
/6042MkII
UJF-3042MkII e/3042MkII EX e
/6042MkII e
dropper
dropper
UJF-3042MkII/3042MkII EX
/6042MkII
UJF-3042MkII e/3042MkII EX e
/6042MkII e
• Until wiper cleaning is competed, [COMPLETED
(NEXT): ENT] is displayed on the screen. After the
work up to the step 7 is completed, press the
[ENTER] key. If you press the [ENTER] key before
cleaning is completed, the machine moves to the
next washing procedure.