MIMAKI UJF-6042 MkII - Setting of AUTO CLEANING; Setting of FAN MODE

3-12
Chapter 3 Setup
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “WORK
CHANGE” , and press the key.
5
Press to select a set value, and
press the key.
• Set value :ON/ OFF
6
Press the key several times to
end the setting.
Setting of FAN MODE
You can set whether the vacuum function to fix the media
set on the table is performed automatically or you perform
it manually.
The factory default is “AUTOMATIC”.
(Only for UJF-3042MkII EX/UJF-3042MkII EX e, UJF-
6042MkII/UJF-6042MkII e or when using an absorption
table.)
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “FAN MODE” ,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : AUTOMATIC/ MANUAL
6
Press the key several times to
end the setting.
Setting of AUTO CLEANING
Set whether auto-head cleaning is executed or not at the
following intervals before drawing.
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “AUTO
CLEANING” , and press the key.
5
Press to select a set value, and
press the key.
• Set value :ON/ OFF
6
Press the key several times to
end the setting.
• When AUTOMATIC is selected, the fan
automatically starts to operate at print start.