MIMAKI UJF-6042 MkII - Setting of INK LAYERS; Setting of REFRESH LEVEL; Setting of UV Adjval; Setting of UV MODE

3-11
Chapter 3 Setup
3
2
2
2
Setting of INK LAYERS
Set the number of times for over painting.
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press to select "INK LAYERS",
then press the key.
4
Press to select a set value, and
press the key.
• Set value : 1 to 9 times
5
Press the key several times to
end the setting.
Setting of REFRESH LEVEL
Set the refreshing revel for preventing the head from
clogging in a dusty environment.
The larger level number indicates more frequent
refreshing times.
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press to select “REFRESH” , and
press the key.
4
Press to select a set value, and
press the key.
• Set value : HOST / Level 0 to 3
5
Press the key several times to
end the setting.
Setting of UV MODE
The mode of the LED UV may be set in 3 stages.
This setting is made when the media vulnerable to the
heat is used or when the test drawing is made in which
the lighting of the LED UV is not desired.
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press to select “UV MODE” , and
press the key.
4
Press to select a set value, and
press the key.
• Set value : ON/OFF/NO PRINT
5
Press the key several times to
end the setting.
Setting of UV AdjVal
The pre-set UV lamp light intensity can be changed.
(FW: supported from UJF-MkII Ver5.2 or later, UJF-MkIIe
Ver2.0 or later)
After printing, check the state of curing (stickiness, odor,
etc.).
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key
• The setting menu is displayed.
3
Press to select “UV AdjVal” , and
press the key.
4
Press to select a set value, and
press the key.
• Set value : -50% ～ 50%
5
Press the key several times to
end the setting.
Setting of WORK CHANGE
Set whether to return to LOCAL or to remain at REMOTE
to set media after on-line drawing.
ON The LED UV is lit.
OFF The LED UV is not lit.
NO
PRINT
The drawing is not performed and only the LED UV
is lit. Use when drawing is performed without the
LED UV is lit etc., and when you wish to make it
cure afterward.
- direction Weak UV curing
+ direction Intensifies UV curing