Mindray BA-88A - Page 48

4-1
0
Figure 4-8 Calculation
The following table explains the parameters on the Calculation screen.
Parameter Description
Test The test name should be set and same test names are not
allowed..
The length of the test name should not exceed 10 characters.
Otherwise, warning messages will appear.
Unit Unit of the result. Select from the drop-down list. The options
include g/L, mmol/L, umol/L, U/L, mg/dL, IU/L, mg/L and void. The
default is void. The units can be added and deleted in Setup.
Precision Precision of the result. Select from the drop-down list 1, 0.1, 0.01,
0.001. The default is 1.
Default
reference
Enter the normal range of the calculation. Refer to 4.2.1.2 for
details.
By Diff. Set the differential reference range of the calculation. Refer to
4.2.1.2 for details.