6
BeneVision N22/N19/N17/N15/N12
Quick Reference Guide
g. Select OK to confirm and return to the main screen.
Note: Find patient from the ADT server is only enabled if ADT Query is
supported.
Note: Loading patient information from the ADT server updates only patient
information in the N Series bedside monitor. The patient’s monitoring data is
unaffected.
Discharge a Patient
The Discharge function clears all patient information and restores default
(preconfigured) settings.
• Swipe down the touchscreen with two ngers, and select Discharge to
con rm.
• Select the Discharge Patient
quick key, and select Discharge to
con rm.
• Select the Patient Management
quick key, and select Discharge
Patient.
• Select the Main Menu
quick key, and select Discharge from the
Patient Management column.
• Select Discharge patient from the standby screen.
And select Discharge to confirm.
STANDBY
Enter Standby
The Standby function allows the clinician to suspend monitoring on a patient.
While in standby, the patient is not being monitored; however, all data and
settings are preserved.
To place a patient into Standby on the N Series bedside monitor:
a. Select the Standby quick key.
Or
a. Select the Main Menu
quick key, and select Standby from the Patient
Management column.
b. Set Location from the drop down list to define where the patient is when
the monitor enters the standby mode.
To Next Page
Loading...
Need help?
General
