P/N: 046-017383-00 Rev1.0
14
BeneVision TM80 Quick Reference Guide
NIBP (OPTIONAL)
The TM80 allows non-invasive blood pressure (NIBP) monitored by a BP10 NIBP
module.
Pair a TM80 with a BP10
1. Press the MPAN key on the right panel of the BP10. The“Pairing...”
message will display in the message area of the BP10.
2. Press to enter the main menu.
3. Tap Wireless Modules.
4. Tap MPAN and then select Connect to BP10.
The TM80 starts searching the BP10 devices in the vicinity and
displays the devices that can be connected under Devices. Make sure
that the device you wish to connect appears in the list of devices. If not,
repeat Steps 1 to 4.
5. In the list of devices, select your desired device and tap Connect. Once
the device is connected successfully, the status will be changed from
Disconnect to Connected.
6. Tap anywhere in the NIBP digital area on the main screen to access the
NIBP menu.
7. Tap Start to start NIBP measurement. Verify that the NIBP measurement
results displayed at the BP10 are consistent with that displayed on the
main screen of the TM80 and are the data for the same patient.
Pair a TM80 with a New BP10
1. Unpair the TM80 with the BP10 already connected by following steps in
Unpair a TM80 with a BP10 via the TM80 or Unpair a TM80 with a
BP10 via the BP10.
2. Pair the TM80 with your desired BP10 by following steps in Pair a
TM80 with a BP10.