Mindray Consona N9 Exp - Page 167

7 3D/4D
Operator’s Manual 7 - 13
Rotate the Image
NOTE:
You can view the back of the VR by rotating it 180°. The back view image may not be as vivid as
the front. (Here we call the initial view of the VR the “front”). It is recommended to re-capture
rather than rotate the VR if a certain desired region is obscured in the VR.
•Axial rotation
Axial rotation is to rotate the 3D image around the X, Y or Z axis.
Rotate the corresponding knobs to make the image rotate:
– To rotate along X-axis: rotate <M> button on the control panel clockwise, the image
rotates right along the X-axis, and rotate the button anticlockwise, the image rotates left.
– To rotate along Y-axis: rotate <PW> button on the control panel clockwise, the image
rotates right along the Y-axis, and rotate the button anticlockwise, the image rotates left.
– To rotate along Z-axis: rotate <C> button on the control panel clockwise, the image
rotates right along the Z-axis, and rotate the button anticlockwise, the image rotates left.
Or, enter the touch screen mapping mode and hide the tool bar. Rotate the image by touching
the image window and move slowly.
– To rotate along the X-axis: flip from top to bottom and the image rotates right along the
X-axis. Swipe from bottom to top and the image rotates to the left.
– To rotate along the Y-axis: swipe from left to right and the image rotates right along the Y-
axis. Swipe right to left and the image rotates to the left.
• Auto Rotation
1. In 3D viewing mode, tap the [Auto Rotation] subtab under [Tools] tab on the touch screen,
system enters into auto rotation preparation state.
2. Select [Left/Right] or [Up/Down] to set the auto rotation direction.
3. Select the angle under rotation range to set the auto rotation range.
4. Set Start position and End position:
– Start position: roll the trackball to view to a certain position, tap [Set Start].
– End position: roll the trackball to view to a certain position, tap [End Start].
5. Set rotation mode: tap for single direction rotation; tap for bidirectional rotation.
Select [Step] to set the auto rotation increment.
6. Tap to start auto rotation. Select [Speed] to adjust the rotation speed.
Inversion
Function: vessel shape is correct with the capture target. The vessel wall is smooth and clear.
Surface Enhancement
This function is to make the edge structure of the image and surface details clearer, so as to enhance
the overall contrast.
Select [Surf. ENH] to adjust the enhancement level.
The higher the level is, the clearer the edge structure of the image is.
iLive Add the light rendering effect based on the general rendering effect.
iLive cannot be selected as sub render mode. When it is set as main render
mode, the sub render mode is disabled.