Comments and Body Marks 9-3
îš„ Tracing
(1) In comment status, tap [Trace] on the touch screen to activate the trace function.
The current image is also displayed on the touch screen.
(2) Control Panel operation:
a) Roll the trackball to the desired position and press <Set> to confirm the start
point.
b) Roll the trackball to move the cursor along the edge of the desired region
and trace the outline of the region.
h Rotate the <Angle> knob counter-clockwise to cancel 1 pixel of trace.
h Rotate the <Angle> knob clockwise to restore 1 pixel of trace.
h Short press <Clear> to clear last trace. Long press <Clear> to delete all
tracing.
c) Press <Set> to finish tracing.
Touch screen operation:
a) Trace around the ROI by touching the touch screen image with your finger.
b) Remove your finger to finish tracing.
h [Clear]: touch to delete traces in reverse order one by one.
h [Clear All]: touch to delete all traces.
c) Click [Exit] to exit tracing.
9.1.3 Adding Comments
The system can be configured with comment text libraries including Abdomen, Cardiology,
GYN (Gynecology), OB (Obstetrics), Urology, SMP (Small Part), Vascular, PED (Pediatric)
Nerve Blocks and EM (Emergency).
îš„ Typing comment characters
(1) To set the comment location:
Roll the trackball or press directional keys on the control panel to move the
cursor to the desired location for comments.
(2) To type the alphanumeric characters:
h Type the alphanumeric characters through the qwerty (The default
characters are uppercase).
h To type the upper characters, press <Shift> on the control panel and the
character key at the same time.
(3) Move to a new line:
In the edit status (the characters are in green color), press <Enter> to move the
cursor to the new line, and the location of the cursor is aligned with that of the
first line.
(4) In the edit status, move the trackball or press the multifunctional knob to confirm
the character added, and the color of the character added turns yellow.
îš„ Adding a comment text
Move the cursor onto the desired comment text in the menu and press <Set> or the
multifunctional knob, and then the system adds the selected comment text on the set
location. The added comment text is in the edit status, so you can edit the comment
text added.
z Add combined comment
a) Press <Menu> or the multifunctional knob to show the menu.
To Next Page
Loading...
Need help?
General
