Setup 12-5
Type Item Description
Brightness/Contrast
Load Factory
To set if use the factory setting values of brightness
and contrast.
Screen
Saver
Screen Saver
To select a system dormancy type.
After screen saver function is enabled, click
[Browse] to select the figure used for screen saver,
and click [Preview] to see the effect.
To set the waiting time before the system enters
dormancy/standby status in the drop-down list
beside “Wait”.
12.1.3 Image Preset
Open the page via [Setup] Æ [System Preset] Æ [Image].
Type Item Description
Reset
Config
Probe To set the default probe model for the system.
Freeze
Config
Status after Freeze To set the system status after image is frozen.
Image
Steer
To set the steer mode in B+ Color +PW imaging
mode.
C&PW: select to adjust the sample volume in
color mode and sample line in PW mode together.
C/PW: select to adjust the sample volume in color
mode and sample line in PW mode individually.
Auto Invert
The spectrum can automatically invert when the
color flow is steered to a certain angle, thus
accommodating operator’s habit of distinguishing
flow direction.
To Next Page
Loading...
