17 Probes and Biopsy
Operator’s Manual 17 - 55
NGB-035
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put the sterile sheath on the probe.
b. Select a proper needle-guided bracket, and match the locating groove with the tab of the
transducer. Mount the bracket onto the transducer.
1 Clamp 2 The clamping nut of left/right clamp
3 The locating position block 4 Groove
5 V-shaped guiding block 6 The pressing block for separating
needle
7 Needle guide hole 8 Needle clamping cover of needle-
guided bracket
9 Needle adjusting nut of needle guided
bracket
10 Angle adjusting base
11 Angle mark 12 Angle locking nut
13 Angle adjusting block 14 Buckle
<1>
<4>
<3>
<2>
<5>
<6>
<7>
<8>
<9>
<10>
<11>
<12>
<13>
<14>
To Next Page
Loading...
