Mindray UA-66 - Testing Operations; Selecting Testing Mode; Setting Sample Number

UA-66 Urine Analyzer Operator’s Manual
- 18 -
4 Testing
The instrument supports 3 testing modes: single mode, slow batch mode and fast batch mode.
U
nder the single mode, the operator is required to press START every time to start a test and can
do 60 tests per hour. Under the slow or fast batch modes, once the operator presses START, the
instrument will start to test strips continuously unless the operator presses ESC to terminate the
procedure. The instrument can test 60 tests per hour under the slow batch mode and 120 tests
under the fast batch mode.
The software of the instrument manages the testing reports by the sample No. and the date.
The sample No. is a 3 digits number from 000 to 999 used to identify a particular sample. That is
to say, the instrument can do up to 1000 tests and save all the 1000 reports in its Flash ROM.
At the main menu( See Figure 2.5 ), use ▲ and ▼ to select “Test”, and press START to enter
“Testing” menu. The instrument will then prompt the operator to decide the testing mode and the
sample No.
4.1 Decide Testing Mode
Test>Test Mode
Single Mode
Slow Batch Mode
Fast Batch Mode
Figure 4.1
3 testing modes are listed on the displayer and the mode used recently is automatically
selected. Using ▲ and ▼ to select the desired mode, then press START , the display goes to the
next step to decide the sample No. If the mode selected by the operator differs from the recently
used mode, the software will save this new setting to the Flash ROM.
4.2 Decide Sample No.
Test>Sample No.
010 --:--:--
011 --:--:--
012 --:--:--
013 --:--:--
014 --:--:--
015 --:--:--
016 --:--:--
017 --:--:--
018 --:--:--
019 --:--:--
Figure 4.2