UA-66 Urine Analyzer Operator’s Manual
- 24 -
Transmitting…
Figure 5.9
Press ESC to stop the transmission.
Select “Print” item of the pop-up menu (see Figure 5.2 ) and press START to print reports of the
selected date. Just as the transmitting process described above, the instrument will ask the
operator to enter the start No. and the end No. Press
START to print the reports between the start
No. and the end No. when the end number was entered. A message box will be shown during the
printing process.
Printing…
Figure 5.10
Press ESC to stop the printing process.
5.2 Report
On the date list (See Figure 5.1), press START to browse the reports of the specified date.
Reports>2002-05-23
*052
08:12:40
LEU neg.
NIT neg.
URO norm.
*PRO +
PH 7.0
*BLD +++
SG 1.015
KET neg.
BIL neg.
*GLU 10
Figure 5.11
If the date is today, the report of the most recently testing will be first displayed, otherwise the
report with the smallest sample No. will be first displayed. Press ▲ to view the previous report
and ▼ to view the next report. Press FUN to show a pop-up menu.
Mark
Select No.
Transmit
Print
Figure 5.12
Note that the “Mark” item will be shown only if the report of today is shown. Use ▲ and ▼ to
select the designed item, press START to perform the corresponding function.
Select “Print” and press START to print the report.
Select “Transmit” and press START to print to the host computer via the RS-232C serial port.
Select “Mark” and press START to mark the report. The mark can be seen at the
To Next Page
Loading...
