Minelab X-Terra 50 - Factory Presets

56
1
2
3
4
5
AL
1
2
3
4
5
AL
1
2
The settings sensitivity, volume,
noise cancel* and ground balance
are saved when the X-Terra is
switched off. To return to the
preset menu values:
Turn the detector off.
While pressing and holding
MENU SELECT, turn the detector
back on, by pressing
POWER once.
During the start up sequence,
release
MENU SELECT.
After the start up sequence, the
factory preset message (FP), will
appear for 3 seconds to indicate
that sensitivity, volume, noise
cancel* and ground balance*
have returned to the preset values.
Press and hold Press once
57