Minelab X-Terra 50 - Editing Discrimination Patterns - Method I

The detector’s preset discrimination patterns
can be edited to create custom patterns.
Method 1 - to reject a specific target
ID using an actual target
In detection, a discrimination segment
will flash, indicating its position on the
discrimination scale and the target’s ID
number will appear on the LCD.
Press
ACCEPT REJECT to reject that target ID.
The discrimination segment and
X icon
will appear and the target ID number will
disappear to indicate the rejected ID.
Check that the target ID has been rejected
by detecting again. There should be no audio
response from that target ID.
1
2
3
4
5
AL
1
2
54