Minelab X-Terra 50 - Erasing Patterns

1
2
3
4
5
AL
1
2
3
4
5
AL
1
2
Press and hold Press once
56
Custom patterns are saved
when the X-Terra is switched off.
To erase custom patterns and
return to preset patterns:
Turn the detector off.
While pressing and holding
PATTERNS, turn the detector back
on, by pressing power once.
During the start up sequence,
release
PATTERNS.
After the start up sequence,
the patterns erased message
(PE) will appear for 3 seconds
to indicate that the current
patterns have been erased and
returned to the preset patterns
.
1
56