Start Up Sequence
When the detector is turned on, there is
a short three note tune during its start up
sequence.
Positive Acknowledgement
The detector emits a short beep for
every accepted key press.
Negative Acknowledgement
The detector emits a low double beep
to indicate an invalid keypress.
Completed
A three note tune indicates the completion
of a function (e.g. noise cancel* channel
calibration).
Patterns Erased / Factory Preset
A six note tune will announce when
these settings are complete.
Error
A six note tune will sound to indicate
a detector error
(Error Messages, pg. 60).
Overload
If the coil is passed across a large shallow
target, the detector will give a repeating
buzzing sound. This indicates that the
target signal is too strong for the detector
to interpret.
Low Battery Signal
When the battery power becomes low,
there will be a short announcement tune
(descending tones) every 60 seconds.
Low Battery Shutdown
A long announcement tune (descending
tones) will sound just before the detector
shuts down.
To Next Page
Loading...
