the height of the head restraints or remove
them.
Before installation
Before installing child restraint systems, en-
sure that the rear seat backrests are locked.
Move the rear seats into the rearmost po-
sition to facilitate installation of the child
restraint system.
On the front passenger seat
Deactivating the airbag
Warning
Active front passenger airbags can injure
a child in a child restraint system when
the airbags are deployed. There is a risk
of injury. Make sure that the front pass-
enger airbags are deactivated and that the
PASSENGER AIRBAG OFF indicator light
illuminates.
After mounting a child restraint system on
the front passenger seat, make sure that the
front passenger airbag is deactivated.
Additional information:
Automatic deactivation of front passenger
airbag, refer to page 163.
Seat position and height
After installing a child restraint system,
move the front passenger seat as far back as
it will go and, if possible, to the highest po-
sition. This seat position and height ensure
the best possible position for the belt and
offers optimal protection in the event of an
accident.
After mounting a universal child restraint
system, adjust the backrest tilt so that the
seat belt sits properly.
If the upper attachment point of the seat
belt is located in front of the seat belt guide
of the child seat, move the front passenger
seat carefully forward until the best possi-
ble seat belt guide position is reached.
Backrest width
Adjustable backrest width: Before installing
a child restraint system on the front pass-
enger seat, open the backrest width com-
pletely. Do not change the backrest width
again and do not call up a memory position.
Child seat security
The seat belts in the rear and the front pass-
enger seat belt can be permanently locked
to fasten child restraint systems.
Locking the seat belt
1. Pull out the seat belt strap completely.
2. Secure the child restraint system with
the seat belt.
3. Allow the seat belt strap to be pulled
in, then pull it tight against the child re-
straint system. The seat belt is disabled.
Unlocking the seat belt
1. Open the seat belt buckle.
2. Remove the child restraint system.
3. Allow the seat belt strap to be pulled in
completely.
Seite 111
Transporting children safely CONTROLS
111
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
