Parking brake, refer to page 126.
Engaging selector lever positions
General information
To prevent the vehicle from moving when
a gear is engaged or when reversing, press
and hold the brake pedal until the vehicle
drives off.
Functional requirements
To engage a selector lever position, the
following functional requirements must be
met:
– To switch from selector lever position P
to another selector lever position, drive-
ready state must be on and the brake
pedal must be pressed.
– Selection lever position P cannot be dis-
engaged until all technical prerequisites
are met.
Engaging a selector lever position
To engage selector lever positions, proceed
as follows:
1. Fasten the driver’s seat belt.
2. Push the selector lever in the desired di-
rection, past the resistance point if nec-
essary. The selector lever automatically
returns to the center position when re-
leased.
With shift paddles: To switch between
selector lever position D and S, tap the
selector lever toward D/S.
Without shift paddles: To switch be-
tween selector lever position D and L,
tap the selector lever toward D/L.
Engaging selector lever position P
Only push the parking brake button when
the vehicle is stationary.
To engage selector lever position
P and the parking brake, press the
parking brake button on the switch
cluster.
The parking brake is applied and the trans-
mission lock is engaged.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is supposed
to roll without its own drive for a short
distance, for instance in a car wash or to be
pushed.
Seite 119
Driving CONTROLS
119
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
