Inside the vehicle
Overview
The power window switches are lo-
cated on the doors.
Functional requirements
To close the windows inside the vehicle, the
following functional requirements must be
met:
– Standby state is switched on.
– Drive-ready state is switched on.
The vehicle key or digital key must be in-
side the vehicle.
Opening windows
To open the windows, proceed as follows:
– On the door, press the power
window switch to the resistance
point.
The window opens while the switch is
being held.
– On the door, pull the power win-
dow switch past the resistance
point.
The window opens automatically. Press-
ing the switch again stops the motion.
Closing the windows
To close the windows, proceed as follows:
– On the door, pull the power win-
dow switch to the resistance
point.
The window closes while the switch is
being held.
– On the door, pull the power win-
dow switch past the resistance
point.
The window closes automatically. Pull-
ing again stops the motion.
Anti-trap mechanism
Principle
The anti-trap mechanism prevents objects
or body parts becoming jammed between
the door frame and window while a window
is being closed.
General information
If resistance or blockage is detected while a
window is being closed, the closing will be
interrupted.
Safety information
Warning
Accessories on the windows such as an-
tennas can impact anti-trap mechanism.
There is a risk of injury. Do not install
accessories in the area of movement of the
windows.
Seite 89
Opening and closing CONTROLS
89
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
