3. in the headliner, press the glass sun-
roof switch forward, past the resistance
point, and hold it there.
The glass sunroof closes with limited
anti-trap mechanism. If the closing force
exceeds a certain threshold, closing is
stopped.
4. Push the switch forward again past the
resistance point and hold, until the glass
sunroof closes without the anti-trap
mechanism. Make sure that the closing
path is clear.
Closing from the lifted position
without the anti-trap mechanism
In case of danger from the outside or if
icing might prevent normal closing, proceed
as follows:
1. Close all doors.
2. Turn on drive-ready state or stop the
vehicle if moving.
3. in the headliner, press the glass sun-
roof switch forward, past the resistance
point, and hold it there.
Initializing after a power
interruption
General information
After a power interruption during the open-
ing or closing process, the glass sunroof can
only be operated to a limited extent. Initial-
izing the system can help in this case.
The system can be initialized under the fol-
lowing conditions:
– The vehicle is parked in a horizontal po-
sition.
– The vehicle will not be moved until the
initialization is completed.
– The drive-ready state is established.
– The outside temperature is above
41 ℉/5 ℃.
During initialization, the glass sunroof
closes without the anti-trap mechanism.
Make sure that the closing path is clear.
Initializing the system
To initialize the system, in the
headliner, press the glass sun-
roof switch upward and hold it
until initialization is complete:
Initialization begins within 15 seconds.
– If the glass sunroof is closed, it opens
then closes again.
– If the glass sunroof is open, it first
closes, then opens and closes again.
Initialization is complete once the glass
sunroof has opened then closed again.
Seite 93
Opening and closing CONTROLS
93
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
