minnkotamotors.com | 29
©2021 Johnson Outdoors Marine Electronics, Inc.
TO "LEARN" REMOTES
ADDING/REMOVING REMOTES
The CoPilot remote came from the factory already "Learned" by the CoPilot receiver. Any additional remotes must be "Learned" by the
receiver. The receiver stores all "Learned" information even when the motor is disconnected from a power source.
Your receiver may learn up to ten remotes. Any additional remotes can be "Learned" using the following steps. This will also work to
"Learn" any remote if all remotes are erased from the receiver.
To "Learn" Remotes
To Erase All Remotes from the Receiver
a. Using a small blunt object such as a pen or
screwdriver, press and hold the Learn Button located
on the side of the receiver.
b. The receiver will emit a continuous tone.
a. Remove power from the CoPilot receiver by
disconnecting the Power Cables, or by making sure
that the breaker, if equipped, is "off".
c. Press any button on the remote.
d. The receiver will beep 4 times confirming that it has
“Learned” the remote successfully.
NOTICE: "Learning" the same remote will not
overwrite previously “Learned” remotes. If the
receiver has “Learned” ten remotes, “Learning" an
eleventh remote will overwrite the first remote.
Power CablesPower Cables
Learn ButtonLearn Button
Right SideplateRight Sideplate
1
2
1
To Next Page
Loading...
Need help?
General
