42 RECORDING - ADVANCED OPERATION
Used for self-portraits, the self-timer will delay the release of the shutter for approximate-
ly ten seconds after the shutter-release button is pressed. The self-timer drive mode is
selected in the basic section of the recording-mode menu (p. 38).
With the camera on a tripod, compose the picture as described in the
basic recording operation section (p. 25). Focus lock (p. 26) can be used with off-
center subjects. Press the shutter-release button partway down to lock the expo-
sure and focus (1). Press the shutter-release button all the way down to begin the
countdown (2). Because focus and exposure are determined when the shutter-
release button is pressed, do not stand in front of the camera when taking a self-
timer image. Always confirm the focus with the focus signals before beginning the
countdown (p. 27).
A countdown timer is displayed on the monitor. During the countdown, the self-
timer lamp on the front of the camera (3) will start to blink and is
accompanied by an audio signal. A few seconds before the expo-
sure, the self-timer lamp will blink rapidly. The lamp will glow
steadily just before the shutter fires.
To stop the countdown, press the up/down keys of the controller
or the menu button. The drive mode will be reset to single-frame
advance after the exposure. The audio signal
can be turned off in the custom 1 section of
the setup menu (p. 74).
Self-timer
1
2
3
To Next Page
Loading...
Need help?
General
