3
Making Copies
3-14 EP2030
Using the Multi Bypass Tray
1 Place the original on the Original Glass and make the control panel
settings.
NOTE
è The following functions cannot be selected for Manual Bypass:
Auto Paper, Auto Size, Book Copy, any of the Finishing Modes,
2-Sided Copying, and File Margin Mode.
2 Swing down the Multi Bypass Tray.
Slide the Guide Plate to the size of
the copy paper.
Slide the Multi Bypass Tray
Extender out when using large-size
copy paper.
3 Load a neat stack of copy paper on
the Tray and insert it until it stops.
NOTES
è The paper should be loaded no higher than the Ä (Max. Level
Indicator).
è Before inserting, fan the paper stack well if you are using OHP
transparencies or translucent paper.
è Correct any curl if you are using thick paper.
è The paper will be copied on the side facing up.
To Next Page
Loading...
