Minolta EP2030 - Making the Users Choice Mode Settings

4
Using the User Mode
4-12 EP2030
Making the User’s Choice Mode Settings
1 Keep pressing the Panel Reset Key
for about 3 seconds.
is shown on the Zoom Ratio
Indicator.
2 Using the Key Pad, enter the
desired Choice Code number. The
Choice Code number is shown on
the Zoom Ratio Indicator.
NOTE
è If you have pressed an incorrect number, press the Clear Key, then
enter the correct number.
3 Press the Start Key.
This enters the choice code
selection and the current setting of
thechoicecodeisshownonthe
Multi-Copy Display.
Panel Reset
Zoom Ratio Indicator Multi-Copy Display
U
123
456
789
0C
Zoom Ratio Indicator Multi-Copy Display
Zoom Ratio Indicator Multi-Copy Display