Interleaf EP5000/EP4000 GENERAL, MECHANICAL/ELECTRICAL
97.04.01
G-5
1149SBG0300A
PRECAUTIONS FOR USE3
To ensure that the copier is used in an optimum condition, observe the following pre-
cautions.
F Never place a heavy object on the copier or subject the copier to shocks.
F Insert the power plug all the way into the outlet.
F Do not attempt to remove any panel or cover which is secured while the copier is
making copies.
F Do not turn OFF the Power Switch while the copier is making copies.
F Provide good ventilation when making a large number of copies continuously.
F Never use flammable sprays near the copier.
F If the copier becomes inordinately hot or produces abnormal noise, turn it OFF and
unplug it.
F Do not turn ON the Power Switch at the same time when you plug the power cord
into the outlet.
F When unplugging the power cord, do not pull on the cord; hold the plug and pull
it out.
F Do not bring any magnetized object near the copier.
F Do not place a vase or vessel containing water on the copier.
F Be sure to turn OFF the Power Switch at the end of the workday or upon power
failure.
F Use care not to drop paper clips, staples, or other small pieces of metal into the
copier.
J Operating Environment
The operating environmental requirements of the copier are as follows.
D Temperature: 10°C to 30°C with a fluctuation of 10°C per hour
D Humidity: 15% to 85% RH with a fluctuation of 10% RH per hour
J Power Requirements
The power source voltage requirements are as follows.
D Voltage Fluctuation: AC115/120/127/220-240V
"10% (Copying performance assured)
)6%, –10% (Only AC 127V)
–15% (Paper feeding performance assured)
D Frequency Fluctuation: 50/60 Hz "0.3%
To Next Page
Loading...
