Minolta EP4000 - Vertical Paper Transport

Interleaf EP5000/EP4000 GENERAL, MECHANICAL/ELECTRICAL
97.04.01
M-80
1156SBM2000A
VERTICAL PAPER TRANSPORT20
The sheet of paper taken up by the Paper Take-Up Roll from the Drawer is fed along
the Paper Guide to the Vertical Transport Rollers. The paper fed by the Vertical
Transport Rollers reaches the Transport Rollers and is then fed up to the
Synchronizing Rollers. The Transport Rollers are turned and stopped by Paper
Transport Clutch CL1. The Transport Rollers are coupled to the Vertical Transport
Rollers by way of gears, meaning that the Vertical Transport Rollers are turned and
stopped in time with the Transport Rollers. Transport Roller Sensor PC54
immediately after the Transport Rollers detects a sheet of paper fed from the
Vertical Transport Section or Manual Bypass Table.
A Paper Dust Remover is fitted to one of the Transport Rollers, collecting paper dust from
the rollers.
The Cover for the Vertical Transport Section (i.e., the Side Door) can be opened and
closed for clearing misfeeds. Right Upper Door Interlock Switch S22 detects wheth-
er or not this Cover is open.
<Control>
Transport Rollers
Transport Roller
Sensor PC51
Right Upper Door In-
terlock Switch
Vertical Transport
Rollers/Rolls
1151T10MCC
1156M019AA
Control Signal Energized Deenergized WIRING DIAGRAM
CL1 PWB-A PJ14A-2 L H 7-F
Control Signal ON OFF WIRING DIAGRAM
S22 PWB-A PJ16A-2 L H 21-I