Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
D-7
No. Part Name Removal Procedure
1 Front Door Swing down No. 1. ! Remove two Front Door hinge shafts.
Remove one belt mounting screw inside the Front Door.
2 Control Panel Raise No. 12. ! Swing down No. 1. ! Open No. 8. ! Re-
move No. 7. ! Swing down No. 14. ! Remove No. 13. !
Remove two control panel mounting screws. ! Remove two
magnet attraction plate screws. ! Unplug one connector
from MSC Board. ! Remove one connector.
3
Original Width Scale Raise No. 12. ! Remove two scale mounting screws.
4
Original Glass
Note:When the Original Width Scale has been removed, use
care not to lose two springs.
5 Rear Upper Cover (Small) Raise No. 12. ! Open No. 14. ! Remove No. 13. ! Re-
move the screw cover. ! Remove one Rear Upper Cover
(Small) mounting screw.
6 Rear Upper Cover Raise No. 12. ! Open No. 14. ! Remove No. 13. ! Re-
move No. 5. ! Open No. 8 ! Remove No. 7. ! Remove
one Rear Upper Cover mounting screw.
7 Right Cover Open No. 8. ! Open the Multi Bypass Table. ! Remove
four Right Cover mounting screws.
8 Right Door
(Manual Bypass Unit)
Open No. 8. ! Remove two cover mounting screws. !
Remove the harness from one wiring saddle. ! Unplug
three connectors. ! Remove two Right Door mounting
screws.
9 Counter Cover Snap off the Counter Cover. (It is secured by catches at two
places.)
10 2nd Drawer <Except 120V Areas>
See p. D-17
11 1st Drawer
<120V Areas>
See p. D-18
12 Original Cover Remove No. 12 by pulling up.
13 Upper Left Cover Swing down No. 14. ! Remove six Upper Left Cover
mounting screws.
14 Left Door (Exit/Duplex
Switching Unit)
See p. D-61
15 Middle Left Cover Remove No. 13. ! Remove two Middle Left Cover mounting
screws.
16 Rear Cover Remove six Rear Cover mounting screws.
To Next Page
Loading...
