4. Getting Started
MiR Fleet PC Getting Started (en) 01/2021 - v.1.5 ©Copyright 2019-2021: Mobile Industrial Robots A/S. 12
4. Getting Started
This section describes how to prepare your robots to join the fleet, start up your MiR Fleet
PC for the first time, and activate your license.
Before activating MiRFleet, you must complete the following actions:
1. Update the fleet robots to software version 2.7.9 or higher. All robots in the fleet must
run the same software version as MiRFleet.
2. Select one robot to be a model robot. After updating the robot, use it to create the entire
site setup you want MiRFleet to use. The model robot must contain all the site data you
need for MiRFleet to run the robots as intended, and all procedures you intend to use the
robots for should be tested on this robot before adding any robots to MiRFleet.
3. Once you have used the model robot to create a complete site, export the site, and save
it on a PC. This site file acts as a backup in case you lose any data when starting up your
MiRFleet.
The following sections describe in greater detail how to update the robot software and
export a site file. For more details on how to create a new site including elements such as
maps, missions, and dashboards, see your robot's user guide and the robot reference guide.
NOTICE
It is important to test your site and all intended uses on a single robot before
integrating it in MiRFleet. It is significantly easier to determine the cause of
any issues before the robot is connected to a fleet.
To Next Page
Loading...