23
3.4 Remove the building in shroud.
Note! If the Combiflow B is to be fitted
with top inlets then the bottom inlet
compression fittings must be swapped
using the quad key with the top inlet
blanking plugs. Make sure all seals are
fitted and components are tightened.
Refer to section: 'Exposed Inlet
Supplies (rising or falling surface
pipework)' and follow instructions 2.4
to 2.5.
3.5 Fit the two brackets (supplied) to the
mixer using the 2 x M4 x 8 mm screws
(supplied).
Note! These can be fitted diagonally
as required to enable easy fitting and
access of the inlet connection.
3.6 If installing the shower into a solid wall,
mark an opening sufficient to
accommodate the shower control
approximately 245 mm x 145 mm on
the surface of the wall.
145 mm
245 mm
Bracket
Bracket
Screw
Building in Shroud
48 mm
48 mm
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
To Next Page
Loading...
