Mira COMBIFLOW - Introduction

3
INTRODUCTION
Thank you for purchasing a quality Mira product. To enjoy the full potential of your
new product, please take time to read this guide thoroughly, having done so, keep it
handy for future reference.
The Mira Combiflow is a pressure balanced shower valve with lever control which
maintains a constant outlet temperature irrespective of changes of inlet pressures
as long as the inlet water temperatures remain the same. It is not a thermostatic
shower control and does not sense supply temperature variations. Therefore, inlet
water temperatures especially the hot, should remain relatively constant.
The Mira Combiflow can be installed with the following packages:
- Fully modulating multipoint gas water heaters.
- Fully modulating combination boilers.
- Unvented mains pressure systems.
- Mains pressurised, instantaneous hot water heated from thermal store
systems.
- Pumped systems.
Showering temperature and flow are adjusted by the shower lever control. The flow
rate is also determined by the supply pressures available at the inlets and internal
flow regulator if used (Note! The 8 l/min flow regulator supplied fitted is recommended
for use with fully modulating combination boilers and instantaneous water heaters).
Shower controls covered by this guide:
Mira Combiflow
Surface mounted pressure balanced shower control for connection to exposed
pipework, for high pressure applications (1.0 – 5.0 bar).
Mira Combiflow B
Built-in shower control for connection to concealed pipework, for high pressure
applications (1.0 – 5.0 bar).
If you experience any difficulty with the installation or operation of your new shower
control, then please refer to "Fault Diagnosis", before contacting Kohler Mira Limited.
Our telephone and fax numbers can be found on the back cover of this guide.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk