14
INSTALLATION
Combiflow
1. Rear Inlet Supplies (rising or falling concealed pipework)
Read the section 'Installation Requirements' first.
1.1 Decide on a suitable position for the
shower control. The position of the
shower control and the shower fittings
must provide a minimum gap of 25
mm between the spill-over level of the
shower tray/bath and the handset. This
is to prevent backsiphonage.
1.2 Use the installation template to mark
the positions of two holes diagonally
for mounting the shower mixer and the
pipe centres.
1.3 For solid walls drill two holes diagonally
with a 6 mm diameter drill and insert
the wall plugs (supplied). For other
types of wall structure alternative wall
plugs may be required.
Hose Retaining Ring
25 mm Minimum
Spill-over
Level
Spirit Level
Installation Template
Alternative Position
Drill 2 Holes Diagonally
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
To Next Page
Loading...
