Mira COMBIFLOW - Operation

41




1. Combiflow and Combiflow B
The Combiflow incorporates a temperature override button that allows the user to
override the preset maximum temperature.
OPERATION
1.1 Pull the control lever to turn on the
water. Push the control lever to turn
off the water.
Note! When the Combiflow is installed
with a fully modulating multipoint or
combination type gas water heater, the
maintained mains water pressure, and
hence the flow, must be sufficient to
keep the heater ignited. Therefore, it
is important to make sure that the flow
knob is used in the fully open position
to help prevent variation in the hot
water supply temperature.
Warning! The Mira Combiflow is not
a thermostatic mixer valve,
reducing the flow by operating the
control lever during showering may
increase the temperature.
1.2 Turn the lever clockwise for warmer
water or anti clockwise for cooler water.
Caution! Operation will be in reverse
if the reversed lever is being used. The
preset maximum temperature can be
adjusted as required to suit both site
conditions and the user's comfort.
Refer to section: 'Commisioning and
Control Assembly Installation,
Maximum Temperature Setting'.
Warning! Operation of the override
button will allow a shower temperature
above the preset maximum.
1.3 To override the preset maximum
temperature depress the override
button and turn the temperature knob
further clockwise while keeping the
button depressed.
Temperature Lever
Override Button
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk