Mira COMBIFLOW - Reversed Inlet Connections

32
REVERSED INLET CONNECTIONS
The Combiflow exposed is supplied with back inlet connections hot left, cold right
and bottom outlet.
The Combiflow B is supplied with bottom inlet connections hot left, cold right and
top outlet.
Reversed Lever required
Reversed Lever required
ColdHot
1.1 If the hot and cold inlet connections have been reversed during installation and
cannot be corrected then a reversed lever with the red and blue indicators fitted
in reverse will be required to indicate correct operation. (Available from Kohler
Mira Customer Service).
Important! The flow regulator must always be installed in the hot side of the
valve. Therefore if the hot and cold inlet connections have been reversed make
sure that the flow regulator is fitted in the filter housing on the hot side of the
valve. Refer to section: 'Commissioning and Control Assembly Installation'
for the flow regulator installation instructions.
ColdHot
Cold Hot Cold Hot
Exposed Built in
Outlet
Flow Regulator
Flow Regulator
Flow Regulator
Flow Regulator
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk