Mirage 2000 - Page 36

INSTALLATION & SETUP
Mirage 2000/4000/6000 User’s Manual
2-33
If desired, you can convert an IR remote keypad into a wired remote keypad and vice
versa.
TO CHANGE FROM INFRARED TO WIRED:
• Remove battery compartment cover from back of keypad.
• Remove batteries.
• Wait 1-2 minutes.
• Plug the keypad cable (available separately) into the empty battery
compartment. Make sure that the battery cover is notched smoothly to
accommodate the cable.
• Set keypad protocol as desired, using “wired” jumper settings.
• Replace battery compartment cover.
• Plug into the 3-pin XLR port at the rear panel of the projector.
TO CHANGE FROM WIRED TO INFRARED:
• Unplug the keypad from the projector.
• Open the keypad back and unplug the keypad cable.
• Wait 1-2 minutes.
• Install batteries (see Section 4).
• Set keypad protocol as desired, using “IR” jumper settings.
• Replace battery compartment cover.
Convertin
g
a Ke
yp
ad
'