Mirion Technologies DMC 3000 - 3 Operation; Fast Entry Mode; Operating Modes

-14-
151153EN-G
DMC 3000 User's Guide
3.1 Fast Entry Mode
The DMC 3000 can be started up using a simplied and quick procedure.
Fast entry must be enabled using DMCUser software.
 When fast entry is enabled, the message "ENtER" (1) is
displayed. Simply pressing one of the 2 control buttons immediately
switches the DMC 3000 dosimeter into Run mode.
 The message "IN" (2) is briey displayed (*).
 The dosimeter switches to measurement mode (3).
 The display starts to indicate the dose measurement.
Note:
There are two congurations of fast entry (Fast entry and permanent fast entry)
- In fast entry, as soon as the dosimeter switches back to Pause mode, the fast entry
mode is disabled. To return to fast entry mode set parameters again.
- If the permanent fast entry mode is set, the DMC 3000 will revert to fast entry mode when back
in Pause.
(*) Depending on the versions, the message "IN" may not be displayed.
(1)
(2)
(3)
Note:
DOSIMASS-DM does not have the
ability to modify the DMC 3000's
parameters.
3.2 Operating Modes
DMC 3000 dosimeter can be used in the following modes:
- Autonomous mode:
Dosimeter's two buttons can be used to set alarm set points and switch
back and forth between Pause and Run.
- Satellite mode:
DMCUser software must be used to congure the DMC 3000.
Readers must be used to turn ON (Run) and OFF (Pause) the DMC 3000.
3- Operation