Mirion Technologies DMC 3000 - Data & Parameters List

-20-
151153EN-G
DMC 3000 User's Guide
States Modes
Data
Hour (1)
Date (1)
Full life dose (1)
Full life duration (1)
Total maintenance dose (1)
Total maintenance duration (1)
Dose (1)
Current rate (1)
Maximum rate (1)
Duration of integration in Run (1)
Remaining time before alarm in Run (1)
Parameters
User name (1)
Dosimeter number (1)
Type of autonomous dose
(cumulated or reset) (1) (2)
Date of next internal
calibration (1)
Dose alarm setpoint (1) (2)
Rate alarm setpoint (1) (2)
Duration setpoint (1) (2)
Dose warning setpoint (1) (2)
Rate warning setpoint (1) (2)
Parameters
Beeps at dose change (1)
Autonomous or satellite ag (1)
Software version (1)
FLASH memory checksum (1)
Worker identier (1)
Worker order task code (OT) (1)
Thermoluminescent lm number
(TLD) (1)
Radiation Work Permit (RWP) (1)
The following data and parameter options are available in Pause and Run mode.
They can be selected and ranked by preference, using
dmc
User software.
(1)This item's availability is based on the dosimeter's conguration.
For example, if the rate display is not chosen the current rate and maximum rate will not be displayed.
In G2 protocol, some data or parameters are not available.
(2)These items are settable in autonomous mode.
(3) See
dmc
User software for the complete list of data and parameters available.
4.5 Data & Parameters List