Take care to not damage the gasket. We recommend to
replace the battery cover every ve years or if gasket is
damage. For proper sealing, equal and proper torque
should be applied on both screws.
When engaging the battery in the compartment, make
sure to follow the polarity indicated by the drawing in
the battery compartment.
Battery Type:
Alkaline 1.5 V AAA LR03
Screw Type:
Torx N° 8, ISO 14583
Engage rst the - side of the AAA battery on the com-
partment (5) by compressing the spring contact and
push the battery into its compartment.
Engage the battery cover bottom side rst (6) and
rotate.
Hand tight with the tool provided (1) at 0.25 to
0.35 Nm (2.2 to 3.1 in.Lb).
Remove the belt clip (2). (See §7.1)
Not necessary with standard or front facing clip.
Unscrew the two screws (3) with the
screwdriver provided with your DMC 3000 (1).
Rotate and remove the battery cover (4).
Disengage the AAA battery on the + side rst (5).
Removal Replacement
To Next Page
Loading...
