10- Add-on Modules
The DMC 3000 is provided with an extension capability at the
bottom of the case.
For this purpose, a 26-pin connector allows connection for the
following:
Bidirectional serial communication
Report alarm signal
Detection module (Hp(10) Neutron, Hp(0,07) beta, etc.)
or Telemetry module (see §2.2)
External power
Before connecting any add-on module, it is necessary to equip
your DMC 3000 with a 26-pin connector, ref. 00153458 on top of the
DMC3000 board and your DMC 3000 must be in Pause.
10.1 Dedicated documentation
DOC003284 for the beta Hp(0,07) module
DOC003285 for the neutron Hp(10) module
15-00100 for the telemetry module
DOC006094 for the PRD module
10.2 Module Attachment
Ensure dosimeter is in Pause mode (i.e not in Run or Sleep mode)
Refer to the dedicated documentation to install the module
26-pin connector
ref. 00153458
Make sure the connecting
board is correctly oriented
To Next Page
Loading...
