Mirion Technologies RDS-31 S - Chirp off and Setting Divisor (CHIRP)

13

 The maximum dose rate is now set to zero.
The display shows the 0.0 µSv/h (0 µrem/h) without blinking
and if no button actions take place within the time-out period,
the display returns to the dose rate.

5.4.3 Chirp Off and Setting Divisor
(CHIRP)
The chirp function can be used to activate or
deactivate the audible or visual chirp and to
select the Chirp divisor. The possible divisors are: 1/1, 1/2, 1/5,
1/10, 1/20 and 1/50. The division affects both the audible and
the visual chirp function.
Note: The audible and visual Chirp can be disabled individually, but
they share the common dividing ratio when enabled.
To see the chirp state:
 Activate the menu (Short [Ξ]) and scroll (Short [Ξ]’s) until
display changes to CHIRP.
 The display shows A:ON| A:OFF depending on the current
state of the Audible Chirp.
V:ON| V:OFF depending on the current state of the Visual
Chirp.
And, H:/1|…H:/50| depending on the current state of the
common dividing ratio.
CHIRPSUB‐menu1&2
...
↓
CHIRP
H:/1 
Divisor
Submenu
↓ ↑
A:OFF
→
Audio
Submenu →
ChooseOption
↓ ↑
V:ON 
Visual
Submenu
↓
...