39
6.1 Display Illumination
The RDS-31 has an Energy Save Backlight feature. This means
that in case the amount of ambient light is sufficient, the
backlight will not be activated regardless of the configuration.
Pressing any button or length will activate the backlight. To
only achieve the backlight activation, press the [
]-button
shortly.
Option Effect
Configuration
1:
When the push button is pressed, the
display backlight is lit for 24 seconds
(timeout mode).
Configuration
2:
The backlight is on permanently
(constantly on –mode).
Configuration
3:
The backlight is off permanently
(constantly off –mode).
Note: There is no method in the instrument menu to change the
configuration.
6.2 Show and Reset Cumulative Dose (DOSE)
The cumulative dose is always measured from the
internal tube, even when using an external detector. The
dose alarm can therefore be used to warn the user even
when using any type of an external detector. The dose is
accumulated always when the instrument is switched On.
Option Effect
Configuration
1:
The Cumulative Dose is not displayed in
the menu.
Configuration
2:
The Cumulative Dose can be checked and
reset using the push button of the
instrument.
Configuration
3:
The Cumulative Dose can be checked, but
not reset through the menu of the
instrument.
6.3 Chirp On/Off and Chirp Rate (CHIRP)
The RDS-31 instrument has both an audible and a visual
pulse indicator, Chirp. These can be individually disabled,
but they share the same dividing value when activated
.
Option Effect
Configuration 1: The chirp configuration is not possible through the
To Next Page
Loading...
