Installation and Configuration Guide
14
Upgrading 3300 CITELlink Gateway Software
Software upgrades for the 3300 CITELlink Gateway are announced through a 3300 ICP product
bulletin and made available on Mitel Online at http://www.ebiz.mitel.com
. To download the
software load, follow the instructions in the product bulletin.
If you upgrade the 3300 ICP controller, check the new software load for a newer version of
3300 CITELlink Gateway software and upgrade if required.
To upgrade 3300 CITELlink Gateway software:
1. Connect to the 3300 ICP controller and transfer the software load to the TFTP server.
2. From the gateway console, load the software (if required) and then reboot the gateway.
It is recommended that you store updates on the TFTP server included with the 3300 ICP.
To upgrade the gateway, you require
• A Maintenance PC with
- A communications program such as “HyperTerminal”
- An FTP utility
- The software load downloaded from Mitel Online
• An RS-232 straight-through cable
Connect a Maintenance PC to the 3300 ICP Controller
1. Connect an RS-232 straight-through cable from the 3300 ICP Maintenance port to the
serial port of the PC with the upgrade software.
2. Launch a communication program (such as HyperTerminal) and configure the PC’s serial
port to use the following settings:
Table 3: PC-to-3300 ICP Serial Settings
Baud Rate
9600
Stop Bits
1
Data bits
8
Flow Control
None
Parity
None
To Next Page