Mitel 3300 - Feature Access Codes; Resilient 3300 ICP Systems Usage

Installation and Configuration Guide
4
Information Required
Before configuring the 3300 ICP and the gateway, record the following information:
 IP addresses for the 3300 ICP controller, external tftp server (if required), gateway unit,
and network router. (Static IP addressing only)
 The directory number (DN), model number, and programming for each Meridian 1 IP set.
Check the part number on the bottom of each set to verify the model number.
 Feature Access Codes programmed on the Meridian 1 phone system. (Optional)
It is recommended that you program the 3300 ICP with the same feature codes where
possible.
Network Checklist
To avoid problems when installing the gateway, perform the following network check:
 Check existing network infrastructure before decommissioning the Meridian 1 phone
system:
- Test installed Meridian 1 IP sets including connections and handset cords
- Tone and test existing cabling
- Ensure the loop length does not exceed the maximum recommended (1600 feet/500
meters)
 Before installing new wall sockets, check existing phone plugs for non-standard wiring.
For example, North American sets installed at a British site may require you to map pins
2 and 5 to 3 and 4 on the phone plug.
 If the network uses DHCP IP addressing, check DHCP server settings:
- Ensure the DHCP server is programmed for the subnet where the gateway is located
- Ensure the DHCP server has enough IP addresses
- Ensure the tftp server referenced is storing the correct version of CITELlink Gateway
software
 Ensure the Layer 2 switch is programmed for 10-Base-T Ethernet 1/2 duplex
Program Meridian 1 IP Sets on the 3300 ICP
Before programming Meridian 1 sets
• Program the DHCP Server (if required)
• Enter IP device licenses
• Program Class of Service (COS), Interconnect Restriction, and Intercept Handling for each
Meridian 1 set
• Program Set Registration and Set Replacement Access Codes
• Program Feature Access Codes
Tip: To minimize user frustration, program the 3300 ICP with the same feature access codes
as used on the old Meridian 1 system.