Before You Begin
5
For more information, see the System Administrator tool Online help.
For each Meridian 1 IP set, you’ll need to:
• Provide the directory number, device type (CITELlink Type 1 or 2), and interconnect
restriction.
• Assign a COS
• Program phone keys
To program a Meridian 1 set (System Administration tool):
1. Launch the 3300 ICP System Administration Tool. For instructions, refer to the Technician’s
Handbook.
2. Choose System Configuration from the Selection menu.
3. Open the Multiline IP Set Configuration form and click Add.
4. Program the set as required. Click Help for more information.
- Set the Device Type as indicated:
- Enter the internal directory number (1 to 7 digits in length) for the phone.
- Enter the Interconnect Number for the phone.
- Click Save.
5. Open the Station Service Assignment form and assign a class of service.
6. Open the Multiline Set Key Assignment form. Refer to “Appendix E: Phone Keys” on
page 27 to identify the number and locations of the personal keys. Note that the M3903
only has personal keys which have been preallocated to be the SuperKey and Down Arrow.
- Select the directory number of the phone from the Multiline Set Key Assignment list.
- From the Softkeys list, select the button number of the key that you want to program.
Click Change Member.
- Program the function of the key in the form.
- Click Save.
Note: IP sets may be programmed using the System Administration tool or OPS Manager. For
more information on programming Multiline IP sets, see the System Administration tool or the
OPS Manager Online Help.
For Meridian 1 model: Use device type: For Meridian 1 model: Use device type:
M2006 CITELlink Type1 A2008 CITELlink Type2
M2008 M2616
M3110 M3820
M3310
M3901
M3902
M3903
M3904
To Next Page
Loading...
