Getting Started
Page 6 Mitel
®
5312/5324 IP Phone User Guide – Issue 2, June 2010
Programmable Buttons
The 5312 IP Phone has 12 programmable buttons.The 5324 IP Phone has 24 programmable
buttons. The top seven buttons on both models are programmed by the system administrator
and cannot be reprogrammed. However, you can program the remaining buttons for quick
access to features or speed-dial entries. See “Using the Dialpad Buttons to Enter Characters”
on page 17 for instructions.
Phone Signals
The IP Phone has several audio and visual signals to indicate feature activity. The following are
a few helpful tips:
• Lit or blinking buttons indicate call or feature activity.
• All phone button lamps illuminate at the same time for a few seconds when the IP phone
is reset or powered on.
• The following actions may cause an error tone:
o Pressing an invalid button combination.
o Selecting a restricted feature.
o Dialing a restricted or invalid number.
o Dialing too slowly between digits.
o Waiting too long before performing the next step.
To correct an error tone, hang up and try again.
• Many features “time-out” if you wait too long before performing the next step. If this
happens, you must start over.
• “Off-hook” means the handset is lifted. “On-hook” means the handset is in the cradle.
• If your IP phone does not have a lamp under the speaker button, the large message
indicator lamp on the top right of the IP phone indicates that the speakerphone is in use.
Button Action
DND Turns Do-Not-Disturb (DND) mode on or off.
Outgoing Selects an outgoing line for external calls.
Call 1 Selects an outside line or answers a call.
Call 2 Selects an outside line or answers a call.
IC Answers an intercom (internal) call.
Comfy Places a conference call.
Fwd Forwards the call to the specified number.
To Next Page
Loading...
