Phoning
Mitel 6940 SIP 51
eud-1765/2.0 – R6.0 – 06.2018
Activate/reply to intrusion
You want to implement intrusion in a current call.
Intrusion allows you to access a current call between two call parties and
listen to their conversation. The call party to which you have initiated intru-
sion is notified (display and sound signals). Your call party can then
respond to intrusion or reject it.
You can block intrusion; see chapter "Protecting yourself against calls",
page 96.
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 102).
Notes: • Your system administrator must grant you intrusion rights.
• Intrusion may infringe on your national data protection provisions or be
permitted only under certain circumstances. If you intend to use this
function, you should therefore notify your call party in advance.
Activating/deactivating do not disturb:
Press the function key for Do not disturb (busy) on/off or Do not disturb (forward-
ing) on/off.
➔The function is activated/deactivated, and is displayed in the status bar.
The message LED on the phone lights up/does not light up. Your callers hear
the busy tone.
Activating intrusion (the users are talking):
1. Press the function key for Intrusion.
2. Enter the call number of the user you want as per the key configuration.
➔The intrusion tone indicates that the function has been activated.
➔If the user has blocked intrusion, connection set up will be cancelled.
Answering intrusion:
Press the Answer softkey.
➔You will be connected with the user who has activated intrusion; the first call
party is put on hold.
Rejecting intrusion:
Press the End softkey.
➔Intrusion will be rejected; you remain connected to your first call party.
To Next Page
