Personalizing your phone
Mitel 6940 SIP 95
eud-1765/2.0 – R6.0 – 06.2018
Changing the PIN
You want to change the PIN used to lock/unlock your phone and to thus
protect your phone settings (more information about locking/unlocking
your phone can be found in chapter "Locking/Unlocking your phone",
page 55).
The digit combination "0000" is set as default. You can select any 2 to 8-
digit combination for your new PIN. The PIN on your phone is changed
using the Self Service Portal only. For more information about the Self Ser-
vice Portal, please refer to "MiVoice Office 400 Self Service Portal",
page 9.
Notes: • The PIN that you have changed locally on your phone cannot be dis-
played or overwritten over the Self Service Portal. Therefore, only con-
figure your PIN via the Self Service Portal of the MiVoice Office 400
communication server.
• Please note that your personal PIN is valid for all your phones in the
one number user concept (see chapter "One number user concept",
page 8).
Enter the display text for the idle state
You want to change the text displayed by your phone in the idle state.
The display text shown in the idle state on your phone is configured using
the Self Service Portal. For more information about the Self Service Portal,
please refer to "MiVoice Office 400 Self Service Portal", page 9.
Local IP settings
Your phone saves phone-specific data such as IP address or memory
space. The input of this data is password-protected; it can therefore only
be carried out by your system administrator. You can however call up the
data.
Calling up the phone status:
Press the Option key.
Press Status.
➔Information is displayed by pressing the settings.
To Next Page
Loading...
